HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

enable remote console on rp7410

 
SOLVED
Go to solution
Mike Roger
Advisor

enable remote console on rp7410


Hi guys,

I'v got an rp7410 and i need to enable the remote console inorder to enable people to connect via modem. When I go to the MP and do er it dose not enable the remote console and the remote led dose not go on.

What is the sequanse of commands on the MP to enable it? if posible how to do it also on the rp 5470

Regards,
Mike
8 REPLIES 8
Joshua Scott
Honored Contributor

Re: enable remote console on rp7410

How are you connected to the MP currently?
What are the chances...
Mike Roger
Advisor

Re: enable remote console on rp7410

Sorry I meant SP not MP, I did the ^B then I'm there
Joshua Scott
Honored Contributor

Re: enable remote console on rp7410

are you using a physical console?
What are the chances...
Mike Roger
Advisor

Re: enable remote console on rp7410

yes
Mike Roger
Advisor

Re: enable remote console on rp7410



Guys ..

This is kind of urgent i'm at the SP>CM prompt but what option to use inorder to enable it.

thank you
Mike Roger
Advisor

Re: enable remote console on rp7410

Sorry I'm at MP:CM> menue
Joshua Scott
Honored Contributor

Re: enable remote console on rp7410

type 'er' and it should give you two options. I think the correct option is 'g'

It will then ask if you want to modify the configuration. you must specify 'y' for yes.
What are the chances...
Federico_15
Occasional Advisor
Solution

Re: enable remote console on rp7410

Hy,
First of all, in order to access the Management Processor for the initial installation, the M cable must first
be connected to the DB25 connector located on the Primary MP/SCSI board. The Primary
MP/SCSI board is located in the lower MP/SCSI board slot.

1. Connect the server to AC power.
2. Check the bulk power supply LED for each BPS.
3. Login to the MP:
3.1. Enter Admin at the login prompt. This term is case sensitive.
3.2 Enter Admin at the password prompt. This term is case sensitive.

Then,
1. At the MP Main Menu prompt (MP>), enter cm. From the MP Command Menu prompt (MP:CM>), enter
lc (for LAN configuration).
2. At the prompt, Do you want to modify the configuration for the customer LAN?, enter y.
The current IP address is shown; then the following prompt appears: Do you want to modify it? (Y/[N])
3. Enter y.
4. Enter the new IP address.
The customer shall provide this address for network interface 0.
5. Confirm the new address.
6. Enter the MP Network name.
This is the host name for the customer LAN. The name can be as many as 64 characters, and include
alpha numerics, - (dash), _ (under bar),. (period), or a space. It is recommended that the name be a
derivative of the complex name. For example, Acme.com_MP.
7. Enter the LAN parameters for Subnet mask and Gateway address.
This information shall come from the customer.
8. Once step 7 is completed, the system will indicate the parameters have been updated and return to the
MP Command Menu prompt (MP:CM>)
9. To check the LAN parameters and status, enter the ls command at the MP Command Menu prompt
(MP:CM>).
Please, ATTENTION:
Remote SP via GPM On Green Dial-in (remote) console enabled
Off Dial-in (remote) console is disabled, or SP not
installed, or SP installed and not active

If there is a cell board, please verify the following procedure.

Bye
Everyone wants resolve its problems. Few know like, and still less understand the way.