- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- HPE 9000 and HPE e3000 Servers
- >
- Re: how to config back the mem?
HPE 9000 and HPE e3000 Servers
1753798
Members
7507
Online
108805
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-26-2007 03:34 PM
06-26-2007 03:34 PM
how to config back the mem?
I have a bank of mem 2GB in SuperDome ( 0a,0b,0c,0d in cell 0), they had been deconfiged beacause SBE(single bit error). I want to know how to remove the deconfig status from them in main menu > . can anyone tell the commands that used to config the mem back ?
Thanks
Rambo
Thanks
Rambo
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-27-2007 05:26 PM
06-27-2007 05:26 PM
Re: how to config back the mem?
Hello
You can use two procedures
1.
From BCH menu:
Enter 'ser' for service menu
DIMMDEALLOC - display dimm information DIMMDEALLOC ON - enable dimm module in cell
2. From EFI shell:
dimmconfig - display dimm information dimmconfig ON - enable dimm module in cell
Don't forget to reset the system to apply the changes! | | | |
You can use two procedures
1.
From BCH menu:
Enter 'ser' for service menu
DIMMDEALLOC
DIMMDEALLOC
2.
From EFI shell:
dimmconfig
dimmconfig
Don't forget to reset the system to apply the changes!
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP