HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

how to disconnect user from GSP console

 
Patti Johnson
Respected Contributor

how to disconnect user from GSP console

Users are not able to connect to the server thru telnet.
I logged in to the console (thru GSP) and was able to connect as root. As soon as I did an su - my_user_name
the connection hung.

Is there anyway to disconnect the original session thru GSP?
I can not telnet into the server.

Thanks,
Patti
6 REPLIES 6
Kent Ostby
Honored Contributor

Re: how to disconnect user from GSP console

Patti --

There is a way to reset the console assuming its a 700/92 or similar.

Power down console. Hold down d key and power up console. Count to about 8 and let go of the d-key.

You should get a message that says "Default configs used, press return to clear."

Hit return and that will "unhang" the console part of the equation.

If it's the session that is hung, you can try the usual:
cntl-C
cntl-D

And then try:

cntl-|

Best regards,

Kent M. Ostby
"Well, actually, she is a rocket scientist" -- Steve Martin in "Roxanne"
Steven E. Protter
Exalted Contributor

Re: how to disconnect user from GSP console

Shalom Patti,

Most GSP's have a network connection. It should be possible at the console to ctrl-b and connect in gsp mode and configure the network connection allowing network access to the GSP device. That's what I'd do.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
Geoff Wild
Honored Contributor

Re: how to disconnect user from GSP console

You can reset the GSP on the back of the server....

Sounds like /home is hung...

Rgds...Geoff
Proverbs 3:5,6 Trust in the Lord with all your heart and lean not on your own understanding; in all your ways acknowledge him, and he will make all your paths straight.
Narayanaswami
Occasional Advisor

Re: how to disconnect user from GSP console

Ctrl+B is the way out...
GSP>CM
Use pc in the command menu
or
Use xd to reset.
Use he li at the GSP> prompt to
find out whether these commands run
in your GSP.
Hope this helps.
You don't need to walk to the server room all the time!!
Sivakumar TS
Honored Contributor

Re: how to disconnect user from GSP console

Hi Patti,

you can use

MP>CM>DI

to disconnect the remote users.

Regards,

Siva.
Nothing is Impossible !
Patti Johnson
Respected Contributor

Re: how to disconnect user from GSP console

Thanks for the replies,
Turned out that a disk was going back in the Fc60 and I had to do a TC to reboot.
DI and even a reset of the GSP did not cancel the active session on the console, so no access was possible without a reboot.

Patti