model of Ethernet card

[T G Manikandan]

btlan3 CLAIMED INTERFACE PCI Ethernet (10110019)
Attached the picture of the server holding the card.

Is this a
PCI 2-port 10/100Base-T ?

Revert

[T G Manikandan]

attachee

[Massimo Bianchi]

Hi,
check in this link, it should.

http://forums.itrc.hp.com/cm/QuestionAnswer/1,,0xdb265bd3782dd711abdc0090277a778c,00.html

Massimo

[T G Manikandan]

I was just finding out what was my card out of these

PCI 2-port 10/100Base-T

PCI 4-port 10/100Base-T

LAN PCI10/100Base-T

[T G Manikandan]

the model is A-500/44

[Massimo Bianchi]

Hi,
with a lanscan we should guess, looking at the BUS path and at a "ioscan -fnkClan" .

Can you post it ?


Massimo

[T G Manikandan]

# ioscan -fnkC lan
Class I H/W Path Driver S/W State H/W Type Description
===================================================================
lan 0 0/0/0/0 btlan3 CLAIMED INTERFACE PCI Ethernet (10110019)
/dev/diag/lan0 /dev/ether0 /dev/lan0
# lanscan
Hardware Station Crd Hdw Net-Interface NM MAC HP-DLPI DLPI
Path Address In# State NamePPA ID Type Support Mjr#
0/0/0/0 0x00306E278C77 0 UP lan0 snap0 1 ETHER Yes 119

[Massimo Bianchi]

Hi,
from the output it can be only the
LAN PCI10/100Base-T,
since you have no other lans.

It should be the built-in lan, from the HW path.

Massimo

[Jayan_2]

Dear TG,

One is lanconsole and other one is a 10/100 mbps lan card

sincearly trust this

HTH

regard

jaayan

[T G Manikandan]

If I am to replace that card with the same model for which product no and model I should go for?

Revert