HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rp2405 Boot Problem

 
Mikikiki
Frequent Advisor

rp2405 Boot Problem

Hallo,
I have problem with rp2405 server. During Boot process I receive errors shown below, and after few moments server shuts down.
I can assume that there is a problem with CPU0 turbocooler, or maybe I am wrong? However I can see that all fans are working.
Is there anybody who can help me?
Thank you in advance,

Following are errors I am receiving:


************* SYSTEM ALERT **************
SYSTEM NAME: uninitialized
DATE: 06/22/2007 TIME: 09:15:50
ALERT LEVEL: 6 = Boot possible, pending failure - action required

REASON FOR ALERT
SOURCE: 6 = platform
SOURCE DETAIL: 3 = cabinet fan SOURCE ID: 0
PROBLEM DETAIL: 4 = fan failure

LEDs: RUN ATTENTION FAULT REMOTE POWER
ON FLASH OFF ON ON
LED State: There was a system interruption that did not take the system down.
Check Chassis and Console Logs for error messages.

0x002000646300405F 00000000 00000000 - type 0 = Data Field Unused
0x582008646300405F 00006B05 16090F32 - type 11 = Timestamp 06/22/2007 09:15:50
A: ack read of this entry - X: Disable all future alert messages
Anything else skip redisplay the log entry
->Choice:a

************* SYSTEM ALERT **************
SYSTEM NAME: uninitialized
DATE: 06/20/2007 TIME: 14:26:36
ALERT LEVEL: 14 = Fatal power or environmental problem prevents operation

REASON FOR ALERT
SOURCE: 6 = platform
SOURCE DETAIL: 1 = cabinet SOURCE ID: 0
PROBLEM DETAIL: 7 = unexpected

LEDs: RUN ATTENTION FAULT REMOTE POWER
OFF OFF OFF OFF FLASH
System Power is Off.

0x002000E76100409F 00000000 00000000 - type 0 = Data Field Unused
0x582008E76100409F 00006B05 140E1A24 - type 11 = Timestamp 06/20/2007 14:26:36
A: ack read of this entry - X: Disable all future alert messages
Anything else skip redisplay the log entry
->Choice:a
*****************************************
4 REPLIES 4
Oliver Wriedt
Valued Contributor

Re: rp2405 Boot Problem

Hi !
What does PS on lanconsole show?

Rgds
Oliver
Luk Vandenbussche
Honored Contributor

Re: rp2405 Boot Problem

It seems to me that you have problems with a fan.
Time to take your support contract and contact HP to replace the fan.
Andrew Rutter
Honored Contributor

Re: rp2405 Boot Problem

hi,

check this manual if you havent already.

http://www.docs.hp.com/en/rp24xx_fan_updte/ch01s01.html?btnNext=next%A0%BB

you are correct it is the CPU0 fan, even if its spinning it may not be fast enough. check if its clean and seated correctly at the cable connection end.

you may need to replace the CPU module, as the fan is part of it.

Andy
Mikikiki
Frequent Advisor

Re: rp2405 Boot Problem

Dear all,
Thank you for your reply. I found solution for my problem. I removed smart fan controller from the cpu0 and server is working properly.
Thank you once again for your help.