HPE Community
HPE 9000 and HPE e3000 Servers
1753315 Members
5577 Online
108792 Solutions
New Discussion юеВ

rp7400 SWC

 
Declan McCann
Occasional Advisor

тАО04-11-2002 08:33 AM

тАО04-11-2002 08:33 AM

rp7400 SWC

How do I config the SWC on an rp7400? I have set the ipaddress, gatway, etc on the GSP via the LC command. When I hit the ipaddress from either telnet or explorer I get the GSP login as normal. What am I missing??

Declan
0 Kudos
2 REPLIES 2
Bill Hassell
Honored Contributor

тАО04-11-2002 09:34 AM

тАО04-11-2002 09:34 AM

Re: rp7400 SWC

That sounds correct. Are you looking for a Unix prompt? If so, you need to switch from GSP mode to console mode (hint: type the co command)


Bill Hassell, sysadmin
0 Kudos
Tom Geudens
Honored Contributor

тАО04-11-2002 09:40 PM

тАО04-11-2002 09:40 PM

Re: rp7400 SWC

Hi,
Is this the information you are looking for ?
http://www.docs.hp.com/hpux/onlinedocs/hw/swc/index.html
http://www.docs.hp.com/hpux/onlinedocs/hw/swc/secureweb/install.html

Regards,
Tom Geudens
A life ? Cool ! Where can I download one of those from ?
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.