HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rp7400 console configuration

 
Jeff Disney
Occasional Advisor

rp7400 console configuration

All,

I have three rp 7400's that I need to verify the console network link negotiation how can I check it? Can these use auto-negotiation or do they have to be hardcoded to a certain duplex.

Thanks,

Jeff
7 REPLIES 7
Uday_S_Ankolekar
Honored Contributor

Re: rp7400 console configuration

The GSP on A/L/N class systems and now have 10/100-BaseT or 10/100/1000-BaseT for the LAN console port. GSP auto-negotiates this port with whatever the connection speed is on the other end.
Control B for GSP prompt and configure lan from there. GSP LS (LAN status) command reflects
what the connection speed is.

-USA..
Good Luck..
Jeff Disney
Occasional Advisor

Re: rp7400 console configuration

I used lc to set up the consoles and ls to verify and it does not provide that info, below is output from the gsp in question:

LAN configuration:
. MAC Address : 0x001083fe9f16
. IP address : 10.224.112.131
. GSP Host Name : kysdfpd6
. Subnet mask : 255.255.252.0
. Gateway address : 10.224.112.1

LAN status: UP and RUNNING

Uday_S_Ankolekar
Honored Contributor

Re: rp7400 console configuration

Yes you are right.. MP Web console show lan actual speed with LS command.
Anyway, 10 base half duplex should work for any web console.
Try with that speed settings


-USA..
Good Luck..
Doug Burton
Respected Contributor

Re: rp7400 console configuration

After setting those params and you can't connect you may want to run the "EL" command on the GSP and also check the network switch. Sometimes the switch is set to 100 when your at 10, etc. etc....
Jeff Disney
Occasional Advisor

Re: rp7400 console configuration

How can you view the configuration of the remote console on the gsp, lc and ls do not show the duplex settings.
Uday_S_Ankolekar
Honored Contributor

Re: rp7400 console configuration

Jeff,
10baseT is the default set.
This doc may help
http://www1.itrc.hp.com/service/cki/docDisplay.do?docLocale=en_US&docId=200000078003484



-USA
Good Luck..
Nguyen Anh Tien
Honored Contributor

Re: rp7400 console configuration

this is command
GSP>>LS
LAN configuration:
. MAC Address : 0x00306e3a41f4
. IP address : 10.0.23.197
. GSP Host Name : ADL
. Subnet mask : 255.255.255.0
. Gateway address : 10.0.23.1
. Link state : Auto Negotiate <<< SPEED HERE
. Web Console Port Number : 2000
LAN status: UP and RUNNING
HP is simple