rp7410 - can't access BCH

[rhinoesterley]

We have one cell board in slot one (the bottom cell) - one core I/O in slot one (the bottom slot), two 36GB 15k HDs... at one point we had this server loaded with HP-UX. We had to change out CPU's and the RAM configuration.

Now we've lost the ability to get to the BCH to load the OS or even see a POST test...

We go to the >CO and see a prompt for what partition to use, or q for quit. We choose the partition and it hangs.

Should we try and use a terminal emulator to try and upgrade all the firmware on the system? I ran a >CM:SYSREV and the firmware numbers were not all the same...

[Khairy]

hi,

from mp, run sl and choose to view errors messages. WOuld be useful if you could post the errors here.

[rhinoesterley]

It turned out to be a couple of bad processors. Thanks.