HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rp8400 npars

 
Sigma
Advisor

rp8400 npars

Hello,

I have an rp8400 which had two npars each configured with two cell boards. I reconfigured it with one npar with all four cells boards. After doing so cell board shows a failure and
I'm getting "core Cell is invalid"

Any ideas?

Thank you
4 REPLIES 4
Highlighted
Prashanth.D.S
Honored Contributor

Re: rp8400 npars

Hi,

Have you checked the firmware level for all the cell boards ? Are they same ? If not get them upgraded to same level and test your setup.

Best Regards,
Prashanth
Sandy Chen
Honored Contributor

Re: rp8400 npars

Hi,

Have you tried CC command? This is for genesis so that your partition will be reset to factory config, it won't be an issue for you since you wanted to be one npar. But you will have to parmodify to add the rest of the cell.

Regards,
Sandy
I never think of the future. It comes soon enough.
Sigma
Advisor

Re: rp8400 npars

Thanks for your help, but the issue has been resolved...there was a problem with chassis 1 in the 8400.

Thanks
Sigma
Advisor

Re: rp8400 npars

Closing thread