HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rp8400 upgrade shows OSP and slave MP as 0.000

 
SOLVED
Go to solution
moonchild
Regular Advisor

rp8400 upgrade shows OSP and slave MP as 0.000

Hi

I upgraded an rp8400 firmware to the latest rev 6.5 that went with no errors.

after resetting the system, sysrev shows the following NOTE that OSP is now = 0.000:

Cabinet FPGA and Firmware revision report

System Backplane :GPM FM OSP
--- -- ---
1.002 1.002 0.000

PCI Backplane:LPM HS
--- ---
1.002 1.000

LPM BOB DRAIN PDHC PDC
---- --- ----- ---- ---
CELL 0 :2.002 1.000 1.000 2.004 17.009
CELL 1 :2.002 1.000 1.001 2.004 17.009
CELL 2 :0.000 0.000 0.000 0.000 0.000
CELL 3 :0.000 0.000 0.000 0.000 0.000

FPGA MP
------- -------
Master Core IO : 2.008 4.025
Slave Core IO : 0.000 0.000

If I try to redo OSP it fails with couldn't get OSP ID. is OSP Programmed

and the MP timesout, I assume due to the OSP.

Any suggestions?
thank you in advance
3 REPLIES 3
Sameer_Nirmal
Honored Contributor

Re: rp8400 upgrade shows OSP and slave MP as 0.000

Did you power cycle the server/npars ?

What version from you upgraded to 6.5?
IT Response
Esteemed Contributor

Re: rp8400 upgrade shows OSP and slave MP as 0.000

Yes I power cycled the npar since the upgrade went with no errors.

going from 4.11 to 6.5
Bharath PSB
Advisor
Solution

Re: rp8400 upgrade shows OSP and slave MP as 0.000

First upgrade PDHC FPGA followed by MP Firmware. Now manually powercycle the entire cabinet (By pulling out the power cables and not the "ru" or "re" commands). This should update the PDHC and MP firmwares. Now upgrade other softwares and do npar resets from MP.