HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

rx4640 - processor 3 error help.

 
Highlighted
Steven Bucek
Frequent Advisor

rx4640 - processor 3 error help.

From the EFI all processors are 'installed and configured' under the MP config menu, but not under hpux os (ex, top: cpu0, cpu1, cpu2).

Attached is the dmesg output. Note the processor deallocation at the end.

Any comments appreciated.


--To go forward, you must backup
4 REPLIES 4
Patrick Wallek
Honored Contributor

Re: rx4640 - processor 3 error help.

Is this perhaps an ICOD processor? Does /etc/rc.log show anything for ICOD software?
Steven Bucek
Frequent Advisor

Re: rx4640 - processor 3 error help.

I checked the rc.log and this is the only ref to ICOD. I can attach the entire log if needed.


Initialize capacity on demand
Output from "/sbin/rc2.d/S602icod start":
----------------------------
"/sbin/rc2.d/S602icod start" SKIPPED


does this help any?
--To go forward, you must backup
timmy b.
Honored Contributor

Re: rx4640 - processor 3 error help.

Steven,
The dmesg output shows errors, which I wouldn't expect if this were an ICOD CPU. I think there is an issue here, and I would recommend that you call HP Support.
There are 10 kinds of people in this world: Those who understand Binary, and those who don't.
Andrew Merritt_2
Honored Contributor

Re: rx4640 - processor 3 error help.

I agree with Timmy, all the MCA lines appear to be indicating a problem with the processor. Are there any other errors before the section you've quoted?

Is there anything shown in the STM info log for the system, or in the event.log file from the HW monitors? (event.log is in /var/opt/resmon/log).

Andrew