HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

sam is only showing 3 processors total/active on L3000

 
Justin DePinto
Occasional Contributor

sam is only showing 3 processors total/active on L3000

We have an L3000 with 4 processors. I was checking sams system properties and it showed only 3 total/active. Where do I go to find out what happened to the 4th processor? Or, how do I try and "re-activate" the 4th processor?
4 REPLIES 4
Bernhard Mueller
Honored Contributor

Re: sam is only showing 3 processors total/active on L3000

check top or sar -m 1 1 to see that you really run on 3 CPUs only.
check syslog.log
check dmesg output

You should not just try to re-activate it without knowing what happended.

Guess this machine is under HW support contract. Open a call at HP.

Regards,
Bernhard
Bernhard Mueller
Honored Contributor

Re: sam is only showing 3 processors total/active on L3000

oops....
I meant:
sar -M 1 1

sorry.
Bernhard Mueller
Honored Contributor

Re: sam is only showing 3 processors total/active on L3000

Also check GSP logs
at the console enter Ctrl-b and log into GSP.
enter sl (show logs) e (error) n (no filter)

You should find some (cryptic) information there.

Regards,
Bernhard
Justin DePinto
Occasional Contributor

Re: sam is only showing 3 processors total/active on L3000

Thanks for the replies..It turns out that the processor was shutdown due to errors.. We will be getting it replaced.