HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

sysrev shows OSP revision on rp7410 as 0.000

 
vladimir_1
Frequent Advisor

sysrev shows OSP revision on rp7410 as 0.000

Run OSP utility also shows its current FPGA version as 0.000. An attempt to upgrade it gives:
Unable to read the OSP ID register, is the OSP programmed?

Power cycle with removing power cords did not help. What's next? Replace system backplane?

Thnx.
1 REPLY 1
Joshua Scott
Honored Contributor

Re: sysrev shows OSP revision on rp7410 as 0.000

Yes, the OSP FPGA (ROM chip) is on the system backplane. Typically when the revision shows as 0.000, it indicates a failed component. Did you have a power failure while attempting to upgrade the firmware recently?

Replacing the backplane would be the next step.

Josh
What are the chances...