HPE 9000 and HPE e3000 Servers
cancel
Showing results for 
Search instead for 
Did you mean: 

unable to boot a v2500 running 11.11

 
Raj D.
Honored Contributor

Re: unable to boot a v2500 running 11.11

Moonchild,

Try to boot manually and see what error you are getting:
- Else , then Try with Single user mode.

from PDC:
MAin:Menu:> path

MAin:Menu:> boot

Interact with ISL, N




Check any error message,


Hth,
Raj.
" If u think u can , If u think u cannot , - You are always Right . "
moonchild
Regular Advisor

Re: unable to boot a v2500 running 11.11

when we boot from DVD it sees all disks but when we boot from bch it only sees the DVD and the tape drive.

If we specify the hardware path from bch comes with no lif area.

bo pri comes back with not a valid path

we reinstalled from DVD to a disk on jamaica box connected and the installation was successful. but when we boot it comes to bch and does not see a disk.

your help is much appreciated.
Michael Steele_2
Honored Contributor

Re: unable to boot a v2500 running 11.11

Hi

And I see absolutly nothing about your LCD Error Codes! Refer to the front panel, what is there?

For example,

LED Fault Symptoms Corrective action
03 FPGA not OK 1. Core Utilities Board (SCUB)
monitoring utilities chip
(MUC) problem.
2. MUC cannot get correct
program transfer from
EEPROM on power up.
â ¢ Cycle the node power
using the Key switch.
â ¢ Call the Response
Center.
04 dc OK error
(Upper Left)
1. Power supply is reporting
failure (dc OK) after
keyswitch is turned on, but
prior to SCUB power on
sequence.
2. This is the first of two or more
supplies reporting failure.
Call the Response Center
Support Fatherhood - Stop Family Law
Highlighted
moonchild
Regular Advisor

Re: unable to boot a v2500 running 11.11

resetting the default path in BCH fixed it

thank you all
moonchild
Regular Advisor

Re: unable to boot a v2500 running 11.11

replacing a memory board carrier mid plane and resetting the default path in BCH