- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- BladeSystem Infrastructure and Application Solutions
- >
- 8/20q Switch to C3000 with B-series 8/12c SAN
BladeSystem Infrastructure and Application Solutions
1753930
Members
9848
Online
108810
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-04-2011 02:01 PM
03-04-2011 02:01 PM
8/20q Switch to C3000 with B-series 8/12c SAN
Hi there,
I'm trying (for a week or so) to connect my C3000 Blade enclosure with HP B-series 8/12c SAN to an HP 8/20q SAN switch.
The SAN I've connected is displayed fine in the 8/20q switch, but the blades in C3000 are not.
Every port on enclosure has SPF to 8/20 switch.
Al the drivers are working in the blades. Enclosure/blades/swithces are on latest firmware.
I've tried fooling around with the zones/interopmode/trunk but I've lost all direction.
If i put B series 8/12 in gateway mode it works, but slow. Do I need to set zones in that configuration?
Can anyone provide some guidance?
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP