- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Removing an enclosure from HPOV without access to ...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-11-2016 06:52 AM
03-11-2016 06:52 AM
Removing an enclosure from HPOV without access to Oneview appliance
Hello,
One of the enclosures in our lab used to be managed by HPOV as part of a testing. When the testing was over HPOV appliance was removed/uninstalled but the enclosure was not gracefully removed from Oneview.
I am wondering what would be the proper process to get this enclosure back to VCM?
Would the following work? or do I need to factory reset everything?
1. Execute clear vcmode from the OA CLI
2. Phyiscally swap the interconnects in bays 1 and 2.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-14-2016 10:54 AM
03-14-2016 10:54 AM
Re: Removing an enclosure from HPOV without access to Oneview appliance
Hello,
I was able to get my enclosure back to VCM mode using the process I mentioned in my thread:
1. Execute clear vcmode from the OA CLI
2. Phyiscally swap the interconnects in bays 1 and 2.
Note: point 2 is really really needed.
Regards,