- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Re: Replacing both OA modules
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-17-2014 04:24 PM - edited 11-17-2014 04:25 PM
11-17-2014 04:24 PM - edited 11-17-2014 04:25 PM
Replacing both OA modules
What's the correct procedure to replace both OA modules in a c7000 enclosure?
- I assume we replace the standby module first.
- Once the new standby is in place, will the settings sync from the primary to the standby?
- Once done, how do we make the standby the active one in preparation for swapping the active one? Do we just pull out the active and it'll automatically fail over?
- When we put in the 2nd new OA, will the settings sync to it from the new active OA?
Hope someone can give me instructions or point me to documentation.
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-18-2014 12:12 AM - edited 11-18-2014 12:13 AM
11-18-2014 12:12 AM - edited 11-18-2014 12:13 AM
Re: Replacing both OA modules
Why replacing both?
However, if you remove the standby first and insert a new module, compare the firmware versions. The settings will be sync'ed if the firmware matches. So do the FW update from the active first (clone). Once this is done, go into the standby menu and select "make the standby active", then proceed with the former primary OA.
Better to update the old modules to a current firmware level before start replacing, if possible.
Hope this helps!
Regards
Torsten.
__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!