- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- HP Virtual Connect Flex-10 and xenserver
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-05-2015 03:08 AM
10-05-2015 03:08 AM
HP Virtual Connect Flex-10 and xenserver
Hi there
I have a HP chasis 7000 with 2 455880-B21 10G switche , and 2 647586-B21 on each server.
One switch is actice and one is standby.
The serverblades is running xenserver with 2 nic bundled as active/active. (one from each switch)
Will this give some performance problems when the switche is active/standby and the xenserver is active/active ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-20-2015 10:47 AM
10-20-2015 10:47 AM
Re: HP Virtual Connect Flex-10 and xenserver
HI MJU
The best configuration who can determine the best performanc is your Swtich Core configuration .
From the Xen perspective you can configure Active/Active or Active/Standby .
But the Scenario will act in different ways ,
Active/Active both sides has ethernet traffic but who will determine the redundance is you SW Core .
Active/Standby On side Active the other one , will show as linked the path inside the Xenserver but wihout Traffic .
The best way is ,configure LACP inside the SwitchCore determineing that path coming from the blade are the same one.
configure bound for each eth path needed than when one path is down the other one will stay up .
Also you can check this document about Vm´s and performance .
Regards ,
Flávio Moreira
HPE Employee
I´m HPE Employee