- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- BL460c Gen8 Not Picking Up EBIPA IP Address
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-18-2013 01:32 PM
07-18-2013 01:32 PM
BL460c Gen8 Not Picking Up EBIPA IP Address
Reginald had a customer quesiton:
********************
Customer has some BL460c Gen8 servers in an enclosure that appear to be holding on to IP addresses based on the old location. We’ve moved the blades around, done a reset of the OA, upgraded the ILO firmware and they still have the old IP address. Is there a way to force the server to pick up the EBIPA IP address for that slot?
************
Input from Hoa:
Connect a monitor and keyboard to SUV dongle, restart the server, press F8 as iLO4 prompt appears (not F8 for ORCA), reset iLO to default value (0.0.0.0), server should get new IP from EBIPA IF you put a check mark ‘enable’ for that bay upon boot up. If that fail, get back in iLO4 from F8 prompt put in its static value.
Info from Will:
Dumb question, but is the iLO IP address statically set in the F8 iLO RBSU? This will override the EBIPA address settings. Also, you can send this iLO script to reset the blade’s iLO to DHCP:
hponcfg X << @ <-----Replace X with the Device bay # of the blade
<RIBCL VERSION="2.22">
<LOGIN USER_LOGIN="Dontcare" PASSWORD="UsingAutologin">
<RIB_INFO MODE="write">
<FACTORY_DEFAULTS/>
</RIB_INFO>
</LOGIN>
</RIBCL>
@
Hope this helps!
**************
Any other suggestions?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-31-2013 12:21 PM
07-31-2013 12:21 PM
Re: BL460c Gen8 Not Picking Up EBIPA IP Address
To blade receives address from EBIPA, iLO network settings must be "DHCP". Is it right for you?