- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- BL660-Gen8 FLB port assignment questions
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-15-2014 11:55 AM
12-15-2014 11:55 AM
BL660-Gen8 FLB port assignment questions
A port mapping question from Bob:
************
Can someone confirm the behavior of a BL660 Gen8 with a single FLB.
If a blade is in slot 3, should the NIC ports show for port 3 or 11 ?
My customer was expecting the 1st FLB to show as port 3. I figure both 3 & 11 would be valid for a full slot blade.
Please confirm “normal” or expected behavior.
**********
Info from Norman:
***********
For your reference. A single image depicting the port mapping assignments for various blade formats.
Note that the term LOM should be replaced/substituted for FLB for ProLiant Gen8 or later.
Note that I/O Capacity will have changed with the introduction of the 20GB Ethernet capability.
Another companion image to explain port mapping (full height single-wide) to customers:
**********
And info from Will:
**********
Yes, this is as designed. Here is a screenshot of a BL660 I have in the lab:
Notice the blade is in Device Bay 1 and the FLB is only using port 9 (covered bottom bay port).
Here is another BL660 with 2x FLBs installed:
This one has FLB2 mapped to port 1. Hope this helps.
*************
Comments?