- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- BL870c i2 moving to another Enclosure
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-26-2012 09:58 PM
09-26-2012 09:58 PM
BL870c i2 moving to another Enclosure
Hi Experts,
We have a plan to move one of our BL870c i2 Server from existing C7000 enclosure to a new Blade Enclosure. Is there any special steps to be carried out for this. Hope I can proceed like the belwo steps.
1. Shut down the Server
2. Remove the Blade interconnect (between two BL 860c i2)
3. Pull out the Monarch Blade and install it on new Enclosure.
4. Pull out the 2nd Blade and install it on new Blade Enclosure.
5. Connect the Blade interconnect.
6. Configure iLO.
7.Create and assaign Server Profiles
8. Power up Blade
Hope this will start up with same h/w and device paths. We have configured APA failover Group on network interfaces using 2 NICs. Hope this will not get disturbed. FC was using passthrough.
Regds,
Pramod
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-27-2012 03:09 AM
09-27-2012 03:09 AM
Re: BL870c i2 moving to another Enclosure
Before starting the operation, check the OA firmware level on the new enclosure and make sure it is new enough to support BL870c i2. Older OA firmwares may fail to recognize the server model and prevent it from powering up.
Other than that, your procedure looks good to me.