HPE Community
BladeSystem - General
1751843 Members
5799 Online
108782 Solutions
New Discussion

Re: BL890ic4 BLADE LINK status: Working or not working?

 
Torsten.
Acclaimed Contributor

‎08-06-2015 06:33 AM

‎08-06-2015 06:33 AM

Re: BL890ic4 BLADE LINK status: Working or not working?

As far as I remember each monarch blade stores the config. This means for ABCD each (or maybe two) of the blades must forget the config, so it starts in default AAAA. Unlikely.

 

I would check the stored values in each blade (ilo:CM> sysset) and firmware (ilo:CM> sysrev) and the logs of this timeframe (ilo> sl ---> "S" as view mode).


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.