- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Looking for help setting Integrity blade serial nu...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-05-2014 02:15 PM
03-05-2014 02:15 PM
Looking for help setting Integrity blade serial number.
Arlan had an Integrity customer issue:
*************
A customer received BL870c i2 blades with “odd slot” blade links, but they were supposed to get “even slot” blade links. So the blades can’t be installed in the available chassis slots.
We have ordered the correct blade links for them, but I know those will show up with an “uninitialized” serial number.
Once the blades are installed and the correct blade link is installed, what’s the procedure to set the serial number on the blade links to what they are supposed to be?
***********
Info from Jay:
**************
The system parameters are all stored in NVRAM of the system board, so watch the console when it finishes POST. It will prompt you to copy the data to the new SBL. If that does not work for some reason, go in to the iLO CM command mode and run SYSSET which will then prompt you to copy over the data. Then you can run the sysset command again which should show that the primary & secondary values are identical.
*********
Comments?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-05-2014 10:32 PM
03-05-2014 10:32 PM
Re: Looking for help setting Integrity blade serial number.
Note: a manual write operation of sysset is password protected.
Hope this helps!
Regards
Torsten.
__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!