HPE BladeSystem Server Blades
cancel
Showing results for 
Search instead for 
Did you mean: 

Looking for help setting Integrity blade serial number.

chuckk281
Trusted Contributor

Looking for help setting Integrity blade serial number.

Arlan had an Integrity customer issue:

 

*************

 

A customer received BL870c i2 blades with “odd slot” blade links, but they were supposed to get “even slot” blade links. So the blades can’t be installed in the available chassis slots.


We have ordered the correct blade links for them, but I know those will show up with an “uninitialized” serial number.

 

Once the blades are installed and the correct blade link is installed, what’s the procedure to set the serial number on the blade links to what they are supposed to be?

 

***********

 

Info from Jay:

 

**************

 

The system parameters are all stored in NVRAM of the system board, so watch the console when it finishes POST.  It will prompt you to copy the data to the new SBL.  If that does not work for some reason, go in to the iLO CM command mode and run SYSSET which will then prompt you to copy over the data.  Then you can run the sysset command again which should show that the primary & secondary values are identical.

 

*********

 

Comments?

 

1 REPLY
Torsten.
Acclaimed Contributor

Re: Looking for help setting Integrity blade serial number.

Note: a manual write operation of sysset is password protected.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!