- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Mixing BL460cG7 and BL2x 220G7 in same enclosure ....
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-26-2011 09:23 AM
04-26-2011 09:23 AM
Mixing BL460cG7 and BL2x 220G7 in same enclosure .. Is there any limitation?
Phunsak had a blade mixing question:
**************
Hello all,
Is it a good idea to mix BL460G7 and BL2x220G7 in same enclosure? I heard nthe BL2x220G7 was designed for HPC environment only .
But I have case that have to do this unless one more enclosure will be added that will effect with customer budget ,
Below is my solution
- 1x c7000 enclosure with 2 units of Cisco 3020 Switch will be installed in interconnect Bay 1 and 2
- 4 units of 2x220 G7 server
- 6 units of BL460G7 server and 2 units of BL460G7+SB 40c
Question ?
Is this valid configuration ? or
Is there any limitation that I will face if we go with this configuration ?
Any feedback is welcome.
*********************
Rob replied:
************************
At a minimum, you need to be careful with the Interconnect Modules and port mappings.
If you need to be redundant with the BL2x220’s, you’ll need to put in an additional pair of Network modules in bay 3 & 4.
*********************
Other comments or suggestions for Phunsak?
Get more info at: http://h18004.www1.hp.com/products/quickspecs/13748_na/13748_na.html