HPE BladeSystem Server Blades
cancel
Showing results for 
Search instead for 
Did you mean: 

NIC problem ProLiant BL460c G7

dmartinez
Occasional Visitor

NIC problem ProLiant BL460c G7

Hello,
I am having problems with eht0 and eth1 in my server. I think the problem comes because NIC1 and NIC2 are disable, but I don't know how can I enable them.

You can see a screenshoot attached.

Can anybody tell me how can I enable them?

3 REPLIES
Torsten.
Acclaimed Contributor

Re: NIC problem ProLiant BL460c G7

Did you update NIC firmware recently?

Maybe with an older version (e.g. SPP 2014.02)?


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
dmartinez
Occasional Visitor

Re: NIC problem ProLiant BL460c G7

Thank you for the answer.

 

The firmware has never been updated. Should I do it?

SwisspostIT
Valued Contributor

Re: NIC problem ProLiant BL460c G7

is the NIC in the BIOS under PCI Device Enable / Disable  "enabled" ?