ProLiant BL460c G7 : 2 NICs connected on the same side , how to connect the on 2 different sides ?

[jbossert]

Hi,

I've got 2 Blades on a C3000 chassis, and their 2 NICS are all connected on the same side (A side only) !

How can i change that and connect one NIC on each side (A and B) ?

Thanks,

J

[Jimmy Vance]

You can't.

Half Height Servers

NICs 1,2 go to I/O bay 1

Mezz Card1 goes to I/O bay 2

Mezz Card2 goes to I/O bays 3 and 4

FUll height servers are mapped in a similiar fashion

Setup guide

http://h10032.www1.hp.com/ctg/Manual/c01167169.pdf

[Sameer_Kulkarni]

If you have a Virtual connect (VC), you may do the configuration as you like to. Where-in you may assign the network port from any of the VC to any server in the enclosure.

---

@jbossert wrote:

Hi,

I've got 2 Blades on a C3000 chassis, and their 2 NICS are all connected on the same side (A side only) !

How can i change that and connect one NIC on each side (A and B) ?

Thanks,

J

---

[Torsten.]

The blades are hardwired to this bay. An additional mezzanine card is hardwired to bay 2, so you need such card. This is specific for the C3000 enclosure.