HPE BladeSystem Server Blades
cancel
Showing results for 
Search instead for 
Did you mean: 

bl45p g1 Memory enumeration errors on dimms 9-16

Koopa
Frequent Advisor

bl45p g1 Memory enumeration errors on dimms 9-16

I have a BL45p that when you look at HP sim, it shows it has dimms in slots 1&2, 5&6, 9&10 and 13&14 as you would expect, but for some reason as the screenshot shows, it shows unknown enumeration value 0 in slots 9-16 which are all slots on secondary board. I have swapped both system boards but still get the same issue. I have also replaced all 4 dimms in 9,10,14 & 14 but still show the following. I've also replaced the dimm in slot 5, so please ignore that. Any ideas what I can try next? I'm going to try and replace the cpu's in the secondary board and see if this resolves but any advice greatly appreciated

 

Thanks

 

Koopa79

1 REPLY
Koopa
Frequent Advisor

Re: bl45p g1 Memory enumeration errors on dimms 9-16

just to add to it, I've also tried swapping cpu's 3 & 4 with 1 & 2 but i still get the same issue. I have also tried moving the blade into different just to make sure it wasn't a fault with the slot. Still get the same error. Does anyone know if this could be a firmware issue? as i've kind of run out of hardware options to try.