HPE Community
BladeSystem - General
1753454 Members
6160 Online
108794 Solutions
New Discussion

SB40c Critical Error help

 
pmumbower
Occasional Visitor

‎04-14-2014 07:31 AM

‎04-14-2014 07:31 AM

SB40c Critical Error help

I am getting a "Power Control fault...state is CRITICAL" error message for a SB40c in one of our c7000 enclosures. The SB40c firmware recently was updated from 1.20 to 2.20. Any ideas on what the fix is for this?

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.