BladeSystem - General
1748092 Members
5964 Online
108758 Solutions
New Discussion

Compatibility | VC Flex 10 E-Net and Flex 10/10D

 
grinningdevil
Frequent Advisor

Compatibility | VC Flex 10 E-Net and Flex 10/10D

Hello! 

Is it possible to have the following - 

Flex10D in Bay 1 and Bay 2 

Flex10 Ethernet Module in Bay 3 and Bay 4 

No Vertical Stacking needed.   Stacking between Bay1 and Bay 2 via Backplane. 

 

 

1 REPLY 1
f_silva
HPE Pro

Re: Compatibility | VC Flex 10 E-Net and Flex 10/10D

Hi

It is possible use because the firmware of the Flex10 and Flex10/10D is the same.

E.g: Details of the 4.50 version

https://support.hpe.com/hpsc/swd/public/detail?swItemId=MTX_1f352fb404f5410d9b2ca1b56d#tab4

Supported Devices and Features:

HPE Flex-10 10Gb Virtual Connect Ethernet Module for c-Class BladeSystem

HPE Virtual Connect FlexFabric 10Gb/24-port Module for c-Class BladeSystem

HPE Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem

HPE Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem

HPE Virtual Connect Flex-10/10D Module for c-Class BladeSystem

HPE Virtual Connect FlexFabric-20/40 F8 Module for HP BladeSystem c-Class

HPE Virtual Connect 16Gb 24-port Fibre Channel Module for c-Class BladeSystem

 

On Flex 10D quickspecs have table with suported configurations (page 6): https://h20195.www2.hpe.com/v2/Getdocument.aspx?docname=c04154336

 

One point in this environment is that in the servers in mezzanine slot 1 you must use only mezzanines of the Network if these modules was installed in bay 3 and 4..


Accept or Kudo