HPE Community
BladeSystem - General
1753816 Members
8690 Online
108805 Solutions
New Discussion

Connect Flex10/10d modules to a single switch

 
schmu56
Occasional Contributor

‎07-11-2014 08:22 PM

‎07-11-2014 08:22 PM

Connect Flex10/10d modules to a single switch

Hi,

 

A customer of mine wants to attach his blade enclosures to a single, unmanaged switch, ostensibly to gain access to his DMZ.  Notwithstanding the obvious (no redundancy, etc.) is it legal to connect a SINGLE uplink from each IC module to one switch?  No VLANS, trunking, SUS, etc. would be involved.

 

Thanks!

 

Scott

0 Kudos
Reply
1 REPLY 1
Robert_Jewell
Honored Contributor

‎08-07-2014 02:05 PM

‎08-07-2014 02:05 PM

Re: Connect Flex10/10d modules to a single switch

A bit dated, I know, but my initial thoughts are that the modules may think they are being stacked.  I guess this depends on exactly how "dumb" the switch is.

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.