HPE Community
BladeSystem - General
1753537 Members
5087 Online
108795 Solutions
New Discussion

Hp c7000 VC flex - Active/Active Shared uplink- FAilover testing

 
Aman1
Occasional Visitor

‎08-22-2017 03:56 PM

‎08-22-2017 03:56 PM

Hp c7000 VC flex - Active/Active Shared uplink- FAilover testing

Hi,

I have created shared uplink sets named VC_A and VC_B. VC_A is connected to port 1.1 on switch A and VC_B is connected to port 2,1 on switch B and  both are in seperate lacp. Both are showing as linkes Active on Virtual connect.

But while testign failover. When i disconnect VC_B , traffic keeps flowing through VC_A without any issues.

But as soon as i disconnect VC_A cable, traffic stops and network goes down., I have enable smart link and made sure that fast cache option is disabled in advance settings as well.

 

Please suggest, i can share more details if required.

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎08-23-2017 09:02 AM

‎08-23-2017 09:02 AM

Re: Hp c7000 VC flex - Active/Active Shared uplink- FAilover testing

I did not work with virtual connect for a long time, so I may be wrong.

But AFAIR the ports of both modules need to be in a single set for failover.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.