- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Multi-Enclosure Stacking Flex10/10-D question
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-12-2015 10:58 AM
03-12-2015 10:58 AM
Multi-Enclosure Stacking Flex10/10-D question
Jean-Yves had a MES question:
************
Hello All
Just a confirmation and hope an explaination is possible, from Installation guide
We need to have same type of interconnect in MES configuration so
Customer can’t create an MES configuration with Mix up of 10/10-d ? (Flex10 in first enclosure and remaining enclosure populated with 10-d)
Is it still true ? why this restriction since customer can’t order anymore flex10 to build a desired MES configuration
Thanks in advance
**********
Reply from Fred:
*************
This restriction is due to port and stacking link differences between the Flex-10 and Flex 10/10D modules.
You can have the customer upgrade the old enclosure to Flex 10/10D. You might investigate outside sources for Flex 10 modules. Or you could configure the new modules in a separate VC domain and direct-connect the old and new domains. If you go with the direct-connect configuration, verify that the failover mode is manual and not auto. That way you can control which path is active on both sides and which is standby.
**************
Comments?