- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Passing double tagged (QinQ) traffic through a VC
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-20-2013 08:48 AM
11-20-2013 08:48 AM
Passing double tagged (QinQ) traffic through a VC
I'm experiencing an issue while trying to pass double tagged through a VC to a blade.
A physical interface on the HP Virtual Connect Flex-10 10GB module is receiving double tagged traffic.
A shared uplink set has the network with outer VLAN from the QinQ traffic assigned.
That same network is configured on the server profile assigned to the receiving blade.
End result: the blade doesn't receive any of the double tagged traffic.
If the traffic is only single tagged (outer VLAN from the QinQ traffic), the blade receives that traffic witout issue.
My conclusion is that the VC drops the packets that contain an inner tag.
Is there a way to ignore the inner tag and just pass that traffic within the outer tag regardless of the contents?
Hopefully someone can clarify this for me.
Thanks in advance.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2017 05:09 AM
03-09-2017 05:09 AM
Re: Passing double tagged (QinQ) traffic through a VC
Having exactly the same issue. Is there any solution?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2017 05:19 AM
03-09-2017 05:19 AM
Re: Passing double tagged (QinQ) traffic through a VC
From what I remember, I had to resort to using the passthrough/vlan tunneling mode.
So basically I haven't configured a shared uplink set but rather used the uplinks directly, defined a ethernet network and enabled vlan tunneling mode.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2017 06:44 AM
03-13-2017 06:44 AM
Re: Passing double tagged (QinQ) traffic through a VC
Thanks, but without using Shared Uplink Set i'm limited by 10G. Uplink Set gives me LAG of several 10G ports together.