BladeSystem - General
1748085 Members
5231 Online
108758 Solutions
New Discussion

Unable to get Network Connectivity on Blades using SUS on FlexFabric VC

 
SOLVED
Go to solution
VIckzz
Occasional Contributor

Unable to get Network Connectivity on Blades using SUS on FlexFabric VC

Hi Guys,

 

I need help urgently. I'm configuring HP FlexFabric Virtual Connect 10/24 Port Module to allow multiple Networks on C7000 Enclosures. They all seem connected and Link is also Active but still blades cannot communicate outside enclosure.

 

Here is what we are using to connect.

 

SUS carrying multiple VLANs
Smart Link

VPC configured on Cisco Nexus 5K Series Switches

 

I'm not sure and it's quite critical to get it up and running.

 

Any Idea?

 

 

PS: Please bear my question as I'm wersed on HP Enclosures.

 

Cheers!

 

Vickz

1 REPLY 1
chuckk281
Trusted Contributor
Solution

Re: Unable to get Network Connectivity on Blades using SUS on FlexFabric VC

I will ask the question. You really don't have a lot of info here. Anything moer you can tell us about the VC Domain profile? Have you looked at the VC for Cisco Nexus5000 white paper?

 

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c02656171/c02656171.pdf