HPE Community
BladeSystem - General
1753925 Members
8865 Online
108810 Solutions
New Discussion

VC can`t find FC modules

 
SOLVED
Go to solution
Outlaw_UA
Occasional Contributor

‎03-05-2017 11:45 PM

‎03-05-2017 11:45 PM

VC can`t find FC modules

Hello !

 

I have c7000 enc with 2x VC Flex-10 Enet Module and 2x B-series 8/24c SAN Switch.

All worked fine.

After delete old vc-domain i can`t properly create new.  In creation process wizard can`t find FC modules. Wizard find 2 Flex-10, 0 - FC and 2 - Unknown.

What is the reason ?

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎03-06-2017 04:10 AM

‎03-06-2017 04:10 AM

Solution

Re: VC can`t find FC modules

Virtual Connect can't manage B-series FC modules.

So you can manage your Flex-10 modules using VC manager, but you need to configure your B-series directly from the switch module interface.

If you need to manage FC modules within VC, you need the VC FC modules, not the brocades.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.