HPE Community
BladeSystem - General
1752788 Members
5990 Online
108789 Solutions
New Discussion

Re: system board replace in HP Blade BL660

 
HPSONU
Occasional Collector

‎11-21-2016 05:55 AM

‎11-21-2016 05:55 AM

system board replace in HP Blade BL660

Hello ,

 

 

I need to know if HP Engineer replaces the syatem board of HP blade BL 640 then what will be the impact at server level ?

Will this chnage result in chnage of mac address and HBA WWN etc etc

 

 

Regards

 

0 Kudos
Reply
1 REPLY 1
Robert_Jewell
Honored Contributor

‎11-25-2016 11:59 AM

‎11-25-2016 11:59 AM

Re: system board replace in HP Blade BL660

It should not affect any MAC or WWN as these controllers are located on seperate riser boards (even the LOM is on its own module).  If the CE does it right, nothing should change from a management point of view.

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.