HPE EVA Storage

1 server x2 HBAs to dual controller HP MSA 2012fc

 
navgeeza
New Member

1 server x2 HBAs to dual controller HP MSA 2012fc

Hello,

I'm trying to configure a MSA2012fc G1 that is to be attached to a DL380G7 with x2 single port HBAs. Intention is to:

1) Attach without FC switch - Using direct attach
2) Have some redundancy between two controllers on the MSA

I've looked at the user guide and have configured it as follows:

- All ports set to loop
- HBA 1 to Port 0 Controller A
- HBA 2 to Port 0 Controller B
- Enabled loop and Interconnect

Whilst both are visible to the VMWare, im noticing a lot of errors in VMWare showing loss to the presented volume and then immediate reconnection.

Any ideas I can try?
2 REPLIES 2
Patrick Terlisten
Honored Contributor

Re: 1 server x2 HBAs to dual controller HP MSA 2012fc

Hello,

which multipathing policy do you use? Fixed, MRU or Round-Robin?

Regards,
Patrick
Best regards,
Patrick
J van der Spank
New Member

Re: 1 server x2 HBAs to dual controller HP MSA 2012fc

I have the same problem. When i enable it I got 4 paths, but after that ports are flapping and I'll got alot of errors.

Someone a solution?