Brocade 4/24 SAN Switch reset to default settings

[Nabil Naameh]

Hi Everyone, I have a C7000 blade enclosure that has 2 brocade san switches inserted.
I am not able to login to the management console through OA, due to credential issues.

how can i reset the san switches to default configuration if I dont know the credentials?

[Patrick Terlisten]

Hello,

can you access the switches with a serial console or/and do you have the ip-settings of the switches? Do you tried the root account?

Regards,
Patrick

[Terri Harris]

Nabil,

Do not use the Brocade factory default reset!

Telnet to your OA IP address. At the OA cli do a

connect interconnect 3

3 = interconnect bay number

Do you know the username and password from the Brocade logon prompt? If these are brand new switches the default is username = admin and password = password
If the password has been losted, contact HP for Brocade password recovery steps. This will require connecting to the internal serial port. This is done by getting first to the OA cli as described above.
The 4/24 has no external serial port.

[Nabil Naameh]

Hi Terri,
I connected through telnet to the interconnect bay where the switch is located and I was able to login to the switch, but when I open the management console of the switch through the OA I get a log in Failed error though I am using the same default usernames I used to login through telnet
(admin, root, fatory, user).
Any idea why I am not able to login to the management console of the switch??

Regards

[Terri Harris]

Enter the IP address of the Brocade switch in a browser (don't go through the OA). Do you get the same logon prompt?
What is the actual error?

[Nabil Naameh]

Yes Terri I get the same prompt when I open the console from a new browser not through OA. After inserting the password for the first 2 times I get nothing but to insert the password again, but after entering the password for the 3rd time I get a login failed message.

[Terri Harris]

What Brocade firmware is running on this switch? 5.3? 6.x?
And is the actual error message "Login failure"?

[AWilliams_1]

Have you tried telnet from the LAN directly to the switch ip address.

[Nabil Naameh]

Terri the Firmware version is 6.2.0d, yes the message is "login Failed"

[Nabil Naameh]

Yes I have tried to telnet directly to the switch IP but it didn't work.