- Community Home
- >
- Storage
- >
- Midrange and Enterprise Storage
- >
- HPE EVA Storage
- >
- CA zoning using MPX 200 router
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-11-2012 10:21 AM
05-11-2012 10:21 AM
CA zoning using MPX 200 router
Hello
What would be considered the correct zoning for CA when the EVA is a P6500 using the MPX200 router. Would I zone FP1 of both controllers to Port 1 of the MPX 200, and FP2 of both controllers to Port 2 of the MPX 200? Or do the MPX 200 act as an ISL and they are not zoned? Any recommendations on how the FCIP route should be configured.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-12-2012 09:51 AM
05-12-2012 09:51 AM
Re: CA zoning using MPX 200 router
Hi
as far as I know MPX200 is considered as ISL and is not zoned look at the quick installation guide
for acceptable configurations
http://h10032.www1.hp.com/ctg/Manual/c02502469.pdf
Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-13-2012 11:35 PM
05-13-2012 11:35 PM
Re: CA zoning using MPX 200 router
When you zone you generally only zone the end-devices.
For anybody to give you recommendations about your FCIP route you need to provide some details about it (speed, latency, etc).