HPE Community
HPE EVA Storage
1753630 Members
6047 Online
108798 Solutions
New Discussion

CV8 with continuous access

 
MárcioAFM
Frequent Advisor

‎07-28-2008 02:26 AM

‎07-28-2008 02:26 AM

CV8 with continuous access

Hello,

I'm need to install CV8 on EVA8100 and EVA4100 so i can make the EVA firmware upgrade to 6.200. My question is:

I have continuous access running on command view 6.02, do i need to configure again the CA on CV8 or the CV8 will detect the continuous access?

Regards,

Thanks

Márcio
0 Kudos
Reply
1 REPLY 1
Víctor Cespón
Honored Contributor

‎07-28-2008 02:31 AM

‎07-28-2008 02:31 AM

Re: CV8 with continuous access

Command View will load the current configuration from the EVA controllers, including the Continous Access setup.
If you use RSM, you need to update it to version 4.0, which is the only one compatible with Command View 8.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.