HPE EVA Storage

Could I disable buzzer of HP EVA 8100?

 
SOLVED
Go to solution
Dennis-Lee
Advisor

Could I disable buzzer of HP EVA 8100?

Hi experts,

  The alerm is noisy. Could I disable it?

4 REPLIES 4
Torsten.
Acclaimed Contributor
Solution

Re: Could I disable buzzer of HP EVA 8100?

Fix the problem and the beep will turn off!


The sound can be disabled on the EMU.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Johan Guldmyr
Honored Contributor

Re: Could I disable buzzer of HP EVA 8100?

Is it disabled via the buttons on the EMU?

Dennis-Lee
Advisor

Re: Could I disable buzzer of HP EVA 8100?

Hi Johan,

  Yes.

 

Muting or unmuting the audible alarm
You may want to mute the alarm in the following situations:
• The error does not require immediate corrective action.
• You cannot correct the error at this time. For example, the error may require a replacement
part.
To mute the audible alarm:
Fibre Channel drive enclosures 37
NOTE: Er is displayed in the alphanumeric display when an error condition is present.
1. Press and hold the bottom push-button until the status indicator is On.
A muted alarm will remain off until a new condition report exists.
2. To unmute the alarm, press and hold the bottom push-button until the status indicator is Off.
When a new error condition occurs, the alarm will sound.
Disabling the audible alarm
CAUTION: Disabling the audible alarm increases the potential of damage to equipment from a
reported but unobserved fault. HP does not recommend disabling the audible alarm.
Disabling the audible alarm affects only one enclosure. This action does not affect condition report

gregersenj
Honored Contributor

Re: Could I disable buzzer of HP EVA 8100?

It can also be disabled from Command View.

 

Or at least, it could be a few years ago, I did it my self. I'm not aware if that feature is available in all version.

 

I do agree on fix the problem, that's way the best solution.

 

BR

/jag

Accept or Kudo