HPE EVA Storage

EVA 4400 and Brocade HBA AP769A Direct Connect

 
Ariel_13
Occasional Contributor

EVA 4400 and Brocade HBA AP769A Direct Connect

Hi
I have 2 DL580G6 with two HBA AP769A(fw 1.1.0.10)each, and Redhat 5.5 and W2K3R2SP2 connected direct to the EVA 4400 with fiber cables to a EVA 4400 fw 9522000. SO drivers 1.1.0.10
Problems:
- I dont have link of FP1 or FP2 of both controllers connected to this HBAs
- Then, I cant map any WWN host on the EVA, and I cant assign Vdisks. The HBA have led link 4GB on, but EVA SFP leds are off.
- Is that configuration supported?

Any ideas?
Greetings
3 REPLIES 3
Mark...
Honored Contributor

Re: EVA 4400 and Brocade HBA AP769A Direct Connect

Hi
You probably need to logon the WOCP and set all the host ports (FP1/2) to direct connect on both ctrls. Remember to save the changes on the "save" button as well.
Mark...
if you have nothing useful to say, say nothing...
Ariel_13
Occasional Contributor

Re: EVA 4400 and Brocade HBA AP769A Direct Connect

Thank you very much

The issue has been resolved. This HBA dont allow direct connect. Im going to change the HBAs.

Greetings
Ariel_13
Occasional Contributor

Re: EVA 4400 and Brocade HBA AP769A Direct Connect

Change HBA for Emulex