HPE EVA Storage

Failed to configure Multipath on Bl460 and EVA8K

 
VICBUR1507
Frequent Advisor

Failed to configure Multipath on Bl460 and EVA8K

Hi Mates,
I try to configure My new BL 460 G7 Debian 6.0 os, with my corporative SAN (brocade swith and EVA 8K storage).
The problem is when I try to configure de multipath because, I see the new lun disk but when restart de server the new lun disk lose.
I put the lun disk information in /etc/fstab but the lun lose the same way.

Any help for this issue. Any docs...

Thanks and reggards.

VB
4 REPLIES 4
ednei
New Member

Re: Failed to configure Multipath on Bl460 and EVA8K

Hello VIC.
So, How did you to setting the MPIO in debian ?
Do you show me the file configuration which contain of the LUN configuration ??
Víctor Cespón
Honored Contributor

Re: Failed to configure Multipath on Bl460 and EVA8K

Debian is not a supported operating system for an EVA8000.

Only RedHat and SUSE Linux are supported, see

http://h20272.www2.hp.com/

ednei
New Member

Re: Failed to configure Multipath on Bl460 and EVA8K

Officially, Debian is not supported, but the issue is other. The problem is in the linux, initiation settings.
Alzhy
Honored Contributor

Re: Failed to configure Multipath on Bl460 and EVA8K

Can you describe how you set up your multipath?

Do you use multipath.conf?

Also how you put disk lun information in /etc/fstab?

If you have device-multipather installed - you should be able to mainatin your mounts accross reboot

Hakuna Matata.