G-port on EVA4400 HSV300-S after FabOS upgrade

[IvanForceville]

Having 2x EVA4400 with HSV300-S controllers

Running V6.3.0b and updated to V6.3.1a.
One of the internal ports of the EVA4400 appears to be switched to a G-port instead of F/E port.

Any thoughts?

[Marcus Schack]

Were there any changes made to the switches? Check the port where this G-port is connected at the switch and ensure that it is ENABLED and that the PERSISTENT ENABLE is turned on.

[Marcus Schack]

If the switch ports look fine. You may want to try this.

Have you rebooted each controller after the upgrade? If the EVA can be shut down, then I would recommend that you do an orderly shutdown/power down. The restart everything and see if that helps.

[IvanForceville]

Thx for your answers.

The issue we saw was related to a failed login of the port during/after the upgrade.

The upgrade was an online upgrade but the ports are going offline/online and there it went wrong for one of the ports.

Unfortantely we have internal switches in the EVA controllers so pulling the cable was not an option.

We disabled/enabled the port and it logged in again...

Luckily...

[IvanForceville]

Disable/enable port forced relogin.