HPE EVA Storage
1748228 Members
4642 Online
108759 Solutions
New Discussion

Re: HP B-series 8/24c SAN Switch

 
Ahmed_Grezly
Occasional Collector

HP B-series 8/24c SAN Switch

Dear My freinds

Good day

I have four HP B-series 8/24c SAN Switch  included in Two HP Enclosure C7000, There IP is configured already.

It is configured to activate only a single blade of my system

I need to enable SAN for another blade, I tried to open Java webapp but it hangs on 19%

I dont know the CLI commands for the system. I need help eaither in opinneng GUI interface or over the CLI Commands

Attached capture of the hung java

3 REPLIES 3
giladzzz
Honored Contributor

Re: HP B-series 8/24c SAN Switch

HI

try using anolder version off java java 6 or java 7 newer versions have security problems

if not u can download CLI guide from internet but it is harder if you are new to this

http://www.brocade.com/content/dam/common/documents/content-types/administration-guide/fos-740-adminguide.pdf

REgards

 

rkjha_hp
Advisor

Re: HP B-series 8/24c SAN Switch

Hi

go to control panel -> java --> security and add san switch ip address as exception site list and try for GUI web page

 

for CLI you can refer brocade cli refernce guide

Rajneesh

Torsten.
Acclaimed Contributor

Re: HP B-series 8/24c SAN Switch

>> go to control panel -> java --> security and add san switch ip address as exception site list and try for GUI web page

 

This will work to get the switch GUI with current java versions.

 

However, depending on switch configuration you probably need to adjust the zoning and depending on the array you need to present LUNs to the certain server.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!