HPE EVA Storage

HP Brocade - Cisco etherchannel (HP trunk)

 
yvading
New Member

HP Brocade - Cisco etherchannel (HP trunk)

I tried to setup an LACP etherchannel between a Cisco switch and a HP brocade.

Only 1 link in the etherchannel (trunk) came up. The rest was in suspended state. In the logging on the cisco device, it was complaining about the remote device.

Could this be due to a licence problem. I know nothing from the Brocade command line. I was not responsible for the configuration of the Brocade. But I'm chasing the cause of the the suspended state.

1) Possible licence problem?
2) How to check? Command

The configuration on the Brocade were the same for all ports in the etherchannel. And the same for the cisco device. (configured via a range command) + config on the portchannel interface.


Thus only 1 port came up.

Thanks in advance.
1 REPLY 1
yvading
New Member

Re: HP Brocade - Cisco etherchannel (HP trunk)

I don't know if this is the good place to start this topic as I really don't know the Brocade device ;-)