- Community Home
- >
- Storage
- >
- Midrange and Enterprise Storage
- >
- HPE EVA Storage
- >
- HP EVA4400 no replications
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-16-2017 09:58 PM
04-16-2017 09:58 PM
HP EVA4400 no replications
Hi All,
I asked the question in a disk-based system sub-category but mybe I shuld ask in this sub category. So:
On the PRimary side is EVA P6300, in working order.
On the DR side is EVA4400. On this storage are replicated Vdisks from the EVA P6300.
EVA4400 has two controllers HSV300, Firmware: 11300000
Command View EVA: 10.3
After Power down of EVA4400(using Command View) and switching on, contoller 1 does not turn on.
On the controller 1 all LEDs are off. From the Command View, controller 1 completly missing.
Controller 2 is working. VMware could start VM on that storage. Obviously over ethernet.
That is hardware issue. Who knows what went wrong. Suggestions?
But, the problem is that the replications stopped working.
Error "Logging/Not merging" is on all DR groups on the source side.
I could not start replication when I manually changed parameter "Replication I/O" from "Suspended" to "Resumed", on the source side.
I created new disk and tried to replicate it and I got the message:
"The local storage system has no available path to the remote storage system".
What should I do to start replications on the storage where working only second controller?
Best regards, Milovan.