HPUX 11.31 and IBM DS5100

[AlexZhang]

I checked the IBM website. It seems that only PVlink is supported. Here is my question, if 11.31 native multi-path doesn't support the array, what is the correct procedure to use just PVlink?
I assume I can just use multiple conventional device file with the one on prefered path as the primary device file. Any other configuration needs to be done?
Thanks.
Alex

[TTr]

See my reply on your other duplicate posting

[IBaltay]

Hi,
see this doc:
http://docs.hp.com/en/native-multi-pathing/native_multipathing_wp_AR0803.pdf

[Sivakumar MJ._1]

Check in Page 167.. if something helps you out...

http://www-01.ibm.com/support/docview.wss?uid=ssg1S7000303&aid=7

Have you checked in the below link (IBM)

http://www-03.ibm.com/systems/support/storage/config/ssic/displayesssearchwithoutjs.wss?start_over=yes

[AlexZhang]

Thank you for the information.

I checked the white paper. There is a setting to disable multi-pathing for Legacy DSF. I believe I should do that before I use PVlink...

Another setting is ADT on IBM side, It should be set to "enabled".

I will let you know once I have it tested.
Thanks,
Alex