HPE EVA Storage

MSA1000 configuration

 
SOLVED
Go to solution
LEO SIMON_1
Advisor

MSA1000 configuration

Dear Sir,

Here is my server configuration :
2 server with each server one only having 1 FC card.
1 MSA1000 with one controller and 1 FC switch controller with type HUB 2/3
And I connected each server to this MSA1000
Can I configured these server and 1 MSA 1000 as cluster configuration using MC/SG ?

Thanks

Leo
4 REPLIES 4
Amol Garge
Trusted Contributor
Solution

Re: MSA1000 configuration

Leo,

Although arbitrated loop is supported, it is not recommended in the clustered environment, because its unstable.

Personally, I would like the 2/3 replaced with a 2/8 internal SAN switch and get a stable environment.
cnb
Honored Contributor

Re: MSA1000 configuration

Leo,

Maybe or maybe not.

Which version of HP-UX and SG are you using?

What Servers and HBA (FC) cards are you using?

What version of Firmware does the MSA1000 run? Is it a single or dual controller? Active/Active or Active/Passive Firmware configuration?

More information is needed to answer your question.

Rgds,
Torsten.
Acclaimed Contributor

Re: MSA1000 configuration

It **may be** working, but since this is really not HA I would use this for testing only.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
LEO SIMON_1
Advisor

Re: MSA1000 configuration

Thanks for all the reply and information